_elem test 2

Print Friendly, PDF & Email

I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.

Turnigy 9xr pro Tx

This is the heading

You can view the details of the Turnigy Tx/Rx here:
-- Transmitter (without the telemetry module): link to the receiver.
-- Transmitter Telemetry Module - link to the telemetry module

Travel Adjust - also called End Point Adjustment, and a few other names. This lets you set the travel limits of each servo, normally as a percentage of the servo's normal travel. The upper limit is typically 125% or so. Travel Adjust can be used to set or fine-tune control surface deflection limits, after all mechanical adjustment has been done.

Sub-trim - this sets the neutral point of each servo, and is handy if you can't get a control surface perfectly neutral with mechanical adjustment (on the linkages).

Leave a Reply

Your email address will not be published. Required fields are marked *